O fundamentos de resistência medição com um multímetro
Há há geralmente três motivos para o ar switch para viagem. Curto circuito, sobrecarga e mau funcionamento.
There is no need to measure the short circuit, and there are obvious and even huge sound and light phenomena. For tripping caused by this reason, as long as the cause of the short circuit is eliminated, then check se the contacts of the air switch are are burned by the short circuit current. Desconectar o nível superior energia supply, so that the air switch is in an absolutely uncharged state, close the air switch, and use a multímetro to measure the three-phase incoming and outgoing wiring terminals of the switch. If the conduction is good, you can try it with power on. If the phase is missing, needless to say, replace the air switch.
In the air switch with a short circuit, the terminals may be broken down. You can use a megger to measure the insulation resistance between the terminals (you can also use a multímetro with a gear above 20K to measure, and remove the inlets on both sides of the air switch. line and outlet). If you start shaking the watch, the pointer of the watch will deflect to the right quickly, indicando que a interfase isolamento de o ar interruptor foi quebrado baixo e não pode ser usado. Se o isolamento resistência é muito grande, mais than a few megohms, you can try it with electricity.
The procedure of power-on trial is as mentioned above. Disconnect the front power supply, turn on the overhauled air switch, and then turn on the front power switch. If the power supply is normal and there is no abnormal sound and smell, the air switch can continue to be used. .
overload. Overload is one of the causes of frequent tripping of the air switch. If you touch the air switch for overload tripping by hand, you will usually feel that the housing is relatively hot, even hot. This will cause the thermal element inside the air switch to produce a protective action.
Use o AC atual intervalo de o multímetro para medida o funcionamento corrente do ar switch. Se o trabalho corrente exceeds o rated current of the air switch e continua para executar, você deve substituir o ar switch com a maior nível de acordo para o real trabalho atual.
Operação indevida. Quando o entrada e saída fios de o ar switch are são alumínio fios, it é fácil oxidar com o cobre terminais de o ar switch, causando calor em os terminais. O térmico proteção dispositivo dentro o ar interruptor é deformado por calor e produz a proteção ação. Este é um típico mau funcionamento. Este problema pode ser resolvido as longo as o cobre-alumínio terminal é pressionado em o alumínio fio e firmemente combinado com o terminal de o ar switch.
